IKB02 SERIES INSTALLATION
Custom HoodPreparation:
1.The custom hood frame must be designed according to the shape and the weight of the insert.Refer to Measurements and Diagrams
2.A sturdy base (3/4 inch thick plywood recommended) is needed to sustain the weight ofinsert.
3.Please install the insert hood left & right stud support (not included)
4.Determine and mark the centerlines on the base of the wood frame where the insert will be installed.
5.Determine the proper location for the Power Supply Cable. Make a wiring access hole using a drill bit. Install the wire cable and seal the gap around hole.
6.Cut out the opening where the insert will be installed.(Figure 1)
Hood Installation
NOTE: USE HAND TOOLS ONLY DO NOT OVER TIGHTEN SCREWS. IT MIGHT CAUSED DAMAGED TO THE HOOD
1.Remove 5 screws located at the bottom of the insert (Refer to Figure 2 and figture 3).
2. Disconnect the 2pcs LED lights wire and switch wire, then carefully remove the light support panel from hood body refer to figture 4
3. Position the insert inside the custom wood frame, refer to figture 5, Secure the insert to the left and right stud support ( Refer to Figure 5) by using the left and right mounting holes (Screws included, 2 holes each side ).
4. Make sure insert is secure before releasing
5. Re-install the light support panel. (Do not over tighten screws.) Refer to figture 6
FinalAssembly
1. lnstall the oil tunnel into recess support near rear of hood, and assemble the handle to stainless steel baffle filters Refer to Figure 7.
2.Install baffle filters. Angle baffle filter toward back of hood 1 . Push baffle filter up until almostlevel 2. Slide forward into recess behind the front of hood 3. Lower baffle filter 4. Slide back until it fits into resting position 5. Refer to Figure 7
1️⃣Angle baffle filter toward back of hood
2️⃣Push baffle filter up until almost level.
3️⃣Slide forward into recess behind the front of hood
4️⃣Lower baffle filter.
5️⃣Slide back untilit fits into resting positions.
